§ 14-131. Required information.

The final plat shall show the following:

(1)

Sufficient data to determine readily and reproduce on the ground the location, bearings and lengths of every right-of-way, street line, lot line, boundary line and building line, whether curved or straight;

(2)

Tract boundary lines, land lot and district lines, city and county limit lines, right-of-way lines of streets, easements and other rights-of-way and property lines of residential lots and other sites;

(3)

All dimensions shall be accurate to the nearest one hundredth of a foot and all angles accurate to the nearest second;

(4)

Name and right-of-way width of each street including necessary right-of-way required for present or future widening of major, minor, collector, residential or other streets as shown on the thoroughfare plan;

(5)

Sidewalk and bike path locations and width;

(6)

House numbers: numbers will be assigned by the geographic information system department and placed on the final plat by the planning department;

(7)

Title, north arrow, date, scale, land lot numbers and district numbers;

(8)

Location, dimensions and purpose of easements and areas to be dedicated to public use, common areas or sites for other than residential use with notices stating their purpose and limitations;

(9)

Intermediate regional floodplain contour line and setback line required by this chapter, state waters/state streams, wetlands, and required stream buffers;

(10)

Water and sewer utility locations, and the location and type of permanent stormwater management facilities and water quality facilities;

(11)

Lots numbered in numerical order and blocks lettered alphabetically; all lot and block numerals shall be kept in a uniform sequence on all plats and units of the subdivision;

(12)

Accurate location, material and description of monuments and markers; within each subdivision set one (1) monument on two (2) front corners of the property adjacent to existing rights-of-way on interior streets, or as otherwise approved by the development director; each monument shall be a minimum four-inch diameter disk by twenty-four-inch high concrete monument with brass caps set flush with finished grade; and

(13)

Lots which shall not be built upon until detailed plans for grading and drainage have been approved by the development director.

(Ord. No. 30-02, Pt. II, 7-9-02)